The StreamBIM measuring tool has gone through a major update. We have introduced the concept of "measuring-plane". This is a clip plane optimized for taking measures.
The idea of the measuring tool is to minimize the need for drawings and drawing production in projects as you no longer need pre-measured drawings. Personnel that needs a measure can derive that themselves directly from the model.
In a measuring plane, you can add multiple measures in the same view, remove irrelevant measures and extend measurement to the next object-intersection of the measuring plane.
When you activate the measuring tool, you will get two options
- "Quick Measure"
Laser vectors generate from where/what the cursor points at. You get a horizontal-, a vertical- and a normal vector. You will get a preview of the direction for the vertical and horizontal beam before measuring.
- "Measure Plane"
It enables you to create a measuring plane. When activated, you will get a preview of which plane that is detected, and when you have the desired measure plane displayed, click to create.
The depth of the plane can be adjusted afterward using the slider in the left side of the screen, so you will only need to make sure it is set in the correct direction (usually a horizontal or vertical plane)
When the measuring plane is set and before you start measuring, the menu will look like this
In addition to the measuring plane slider, you can align view facing the Measure Plane (90°) by clicking the 3D cube.
When you start measuring you will also have the ability to remove all measurements and start over in the same plane. The menu will then look like this:
- Activates "Measure plane-slider" (to change dept of the measuring plane)
- Align view 90° facing Measure Plane
- Removes all measurements taken in the plane
- Closes the measuring tool including measure plane
Measurements in StreamBIM use the geometry of the IFC file, and measurements are therefore dependent on the accuracy in the IFC. Measurements are rounded to the nearest mm (metric) and 1/16'' (imperial).
Working with measurements
When you have started measuring you can edit measuring vectors. You can remove measurements one by one using the "X".
All vectors can also be extended in both directions. This is done by selecting the relevant vector and then use the arrow symbols « » to extend in the needed direction.
Choose to go right, » and the vector extends to the next intersection in the measuring plane.
To deactivate edit mode, double click (random) in the screen